My problem is that I do not know my way around the BIOS, at least with respect to such things as adding controller values, toggling Legacy support, and so forth.Īll I've accomplished so far is to get pretty confused. So, maybe if I add or change some lines in the BIOS, then Drive Image in its DOS mode might be able to detect my USB hard drive. However, from everything I read, it seems that my BIOS is missing instructions to load the USB drivers at the proper point when DOS could use them. I can use windows explorer to see the recovery sets on the drive. Ghost detects the drive, shows it is full, but doesnt show that there are any recovery sets. I wanted to use manage backup destinations to remove older recovery sets. I don't know whether any of the above is pertinent to me, since my Windows 98SE recognizes my USB hard drive. I have offsite backup enabled to a USB drive with an alias assigned to that drive (XP SP3). I assume you are plugging your USB drive directly into a USB 2.0 or 3.0 port on the motherboard itself, and not into a USB hub or front panel on your case. You can then boot the floppy that loads the drivers and switch to the floppy that contains Drive Image." If Liveupdate isnt updating you to a newer version than that then there is something wrong with your board or you are not properly renaming the necessary files. I can delete those almost faster than a couple sneezes. You may need to do this on a different floppy than the bootable floppy that Drive Image creates, since there is very little space available on it. Look at all the light grey icons that reference usb flash drive names. If you plan on running Drive Image after booting from floppy disk, then you will need to create a bootable floppy that contains an AUTOEXEC.BAT and CONFIG.SYS that load the drivers. If its a Norton Ghost product then check the sticky posting at the top of this forum for a link to the Norton Community. During this boot procedure, those are the files used to boot instead of the DOSSTART.BAT. Hi, I have Norton Systemwork 2003, which has Norton Ghost. If the device is getting recognized in disk management or in the Computer, then this might not be problem with USB drive. If you plan on running Drive Image after booting straight into DOS mode by pressing F8 during bootup and then choosing to boot to the Command Prompt Only, the drivers need to be loaded into the AUTOEXEC.BAT. Can Norton Ghost clone a primary hard drive to a USB harddrive Feb 2, 2005. If you plan to run Drive Image this way, you need to also install the DOS drivers and then copy into the DOSSTART.BAT the lines the installation adds to the AUTOEXEC.BAT. The DOSSTART.BAT is located in the Windows subdirectory and is used by Windows instead of your AUTOEXEC.BAT when you Shut Down and Restart the computer in DOS Mode. If you run Drive Image by booting into Windows 95, selecting the icon for Drive Image, and allowing it to boot to DOS, then you need to modify the DOSSTART.BAT to include the drivers. "Depending on how you start DOS, there are three scenarios for loading drivers: More on my problems getting DOS to detect my USB drive: Info from Drive Image (which I have and which, so far, does not see my USB device):
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |